Quantum QTM300CA Guia do Utilizador

QTM300CA USER'S GUIDE Cloning Adapter for the QT3xx family of QProx™ ICsThe QTM300CA is acloning adapter designedto interface between anyQT3xx 8

Table 1 - Clone Cable Functional Pinout - Usage by PartSCKSCKSCK7VccVccVcc6SDOSDOSDI5N/CN/CN/C4SDISDISDO3N/CN/CDRDY2GNDGNDGND1QT320QT310QT300PinTable

Quantum Research Group Ltd.651 Holiday Drive Suite 300Pittsburgh, PA 15220USATel: +1 (412)391-7367Fax: +1 (412)[email protected]

To begin using the board right away1. Connect the QTM300CA to a PC using the serial cable (included). Make sure theserial port is not being used by an

Figure 1 - Board LayoutIf a QT3xx chip has been auto-detected, this button will clone Setups data from theQTM300CA to the chip. The ‘PROG’ LED (see b

Indicates the programming status of the target chip in Stand-alone mode.The PROG LED will light during the cloning process in Stand-alone mode.Afterwa

Figure 2 - QT3View ScreenRestores a config file saved by (File | Save). All three part selector configurations (tabs)will be restored by this action.

The status bar at the bottom shows the serial port and connection status.Possibilities are:Serial Port Status: - Off Line- COM1: 57600 N 8 1- COM2: 57

Cloning Directly to a ChipYou can read and clone back information to a QT3xx chip directly from your PC without involving the onboardstand-alone memor

Clone the Setups to the Chip:Push the PROG button on the board.The PROG LED will light to indicate programming status.The PROG LED will flash to in

Make sure the power supply is compatible with the chip requirements.QT300If the Synchronization input is used, a 1K resistor should be used to avoid