
CHAPTER 5: Using Your Tape Drive SDLT 220 and SDLT 320 Product Manual
5-10 March 2004 81-85002-01
5.5 Front Panel Controls and LEDs
All controls and LEDs are located on the tape drive’s front panel. See Figure 5-1
on page 5-11 for details. Control and LED functionality are described in Table 5-2
and Table 5-3. Use these controls and LEDs to operate the tape system and monitor
the tape system’s activities.
This section also describes the behavior of the amber-colored LED (formerly Write
Protect) on the SDLT 320 drive. This LED is now defined as the Density Indicator,
as shown in Table 5-2.
Table 5-2. Behavior of the Amber LED When a Tape Cartridge is Loaded
Cartridge Type SDLT 220 SDLT 320*
DLTtape IV [includes DLT 1
(Benchmark)]
LED is illuminated LED is not illuminated
Super DLTtape I LED is not illuminated LED is illuminated for other
reasons
‡
* Firmware revision V45 or higher.
‡ Amber LED is used as a Density Indicator on SDLT 320.
Comentários a estes Manuais