Quantum LTO-4 (Model B) Informações Técnicas descarregar pdf (Página 7)

Installing the Internal LTO-4 (Model B) Half-Height Tape Drive 7

Product Line

Mount the internal drive in a 5.25-inch, half-height drive bay as follows:

1 As required:

a Save

and close your open files and terminate all running applications.

b Shut down

the workstation or server system.

c Disconne

ct the system AC power cord from the facility AC power receptacle.

2 Remove the cover from the workstat

ion or server system.

Note: See your computer manufacturer’s instructions for the proper procedures to

remove the cover.

3 Select an available 5.25-inch half-height bay and, if required, remove the bay cover.

4 P

osition the drive in the bay and align either the upper or lower mounting holes—

whichever is appropriate—with the holes in the chassis (see figure

5).

5 Secure the drive using t

wo M3.0 X 3 metric screws on each side

Caution: Using screws longer than 3 mm can damage the drive.

Do not

use screws longer than 3 mm to secure the internal LTO-4 (Model B)

Half-Height Tape Drive.

After mounting the internal LTO-4 (Model B) Half-Height Tape Drive, proceed to

Connecting the Internal Drive Interface and DC Power Cables

in the following

subsection.

Figure 5 Internal Tape Drive

Mounting Hole Locations

Lower mounting holes

Upper mounting holes

Connecting the Internal

Drive Interface and DC

Power Cables

As shown in figure 6, the rear panel of the internal LTO-4 (Model B) Half-Height Tape

Drive has connectors for:

• Either a 68-pin parallel SCSI or a 29-pin SFF-8482 serial-attached SCSI (SAS) interface

cable

• A serial library interface cable

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

Sem comentários

Quantum LTO-4 (Model B) Informações Técnicas Página 7