Quantum Qflash X4d Instruções de Operação descarregar pdf (Página 5)

3.1 Inserting the Flash Tube

Match the red dot on the flash tube base with the red dot on the socket.

Push the flash tube in until it is seated snugly into the socket. Excessive

force is not required.

Replace the flash tube only with Quantum type QF30 or QF30uv for

Qflash model T4d. Qflash model X4d requires QF32 or QF32uv flash

tubes. Other flash tubes will not provide proper exposure, may not work

at all, or they may damage the Qflash.

3.2 Reflectors and Bare Bulb

Reflectors are secured by the

locking ring near the base of

the flash tube. Rotate the ring

in the directions shown in the

diagram to loosen or tighten the

reflectors.

When inserting a reflector, first slowly

rotate it until the notch in the reflector

“drops” fully into the reflector collar.

Then tighten the locking ring. If you don’t let the

reflector drop fully in before locking it may later

become loose.

Note to previous Qflash T, T2 ,X or X2 owners: There is no longer a

“Wide” or “Normal” position for the reflectors. The only position is

“Normal”. For wide angle coverage, use the included diffusers or option-

al QF67A or Soft Box QF68.

3.3 Bounce and Swivel Head

The head position is locked and can be changed

with a single button (see diagram). Press

and hold this button, then adjust the

head to the desired position.

Release the button, and slightly

move the head until it “clicks”

and locks in vertical and hori-

zontal planes.

3. SETTING UP Qflash

1 2 3 4 5 6 7 8 9 10 ... 43 44

Sem comentários

Quantum Qflash X4d Instruções de Operação Página 5