Quantum Qflash X4d Instruções de Operação descarregar pdf (Página 26)

Quantum Qflashes can be coordinated and controlled wirelessly using

Quantum FREE

WIRE

™

Digital Transceivers. Qflash types can be mixed

(Section 8.2), or only Qflash 4d’s can be used.

FREE

WIRE’s connected to Qflashes need to be set for the “TTL” option.

The procedure, explained in detail in the FREE

WIRE instructions, is

summarized below:

Note: When connected for Wireless Control, all FREE

WIRE Zones of

FREE

WIRE’s no longer operate independently. Regardless of the Zone

selected, all units will respond. However the FREE

WIRE Channels

remain independent. To get FREE

WIRE units to work together, set all of

them to the same Channel. To avoid interference from different systems,

set each system of FREE

WIRE’s to its own unique Channel.

For wireless flash sync with Radio Slave or other radio triggers see

Section 8.4.

8.1 Wireless Control using only Qflash Model 4d’s

Wireless Control Mode allows you to set the parameters of remote Qflash

4d’s from one “Control” Qflash, much like the Wired Control Mode of

Section 7, except without wires.

Connect all Qflashes to FREE

WIRE’s with FW 31 Control Cables.

Connect one Qflash to the camera with a sync cord, TTL adapter, or a

QTTL (D series) adapter.

8. MULTIPLE Qflash OPERATION -

WIRELESS MODE

• Turn off FREE

WIRE. Disconnect external power if connected.

• Switch Local/Relay switch to Relay.

• Switch Zone 2 to “+” and set other Zones to “-”.

• Press and hold TEST, then power up FREE

WIRE, and

continue to hold TEST until STATUS blinks twice.

• The FREE

WIRE TTL option is now selected and will remain so,

until deselected by the Options procedure in the FREE

WIRE

instructions.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 43 44

Comentários a estes Manuais

Sem comentários

Quantum Qflash X4d Instruções de Operação Página 26

Comentários a estes Manuais

Manuais e produtos relacionados com Lanternas Quantum Qflash X4d