Quantum 200D/400D Guia do Utilizador descarregar pdf (Página 32)

20 Operation and Maintenance

Data Protection

Write-Protection of the Data Cartridge While Inside the Drive

The Write-Protect switch on the data cartridge can be moved while the

cartridge is loaded into the drive. The drive will turn on the Write Protected

LED immediately. However, if the drive is writing to the cartridge, write

protect does not take effect until the write operation is completed.

 If you move the Write-Protect switch from the write-protected position

(to the right) to the write-enabled position (to the left), the cartridge

becomes write-enabled immediately.

 If you move the Write-Protect switch from the write-enabled position

(on the left) to the write-protected position (to the right), the cartridge

becomes write-protected immediately.

Write-Protection of the Data Cartridge Outside of the Drive

Move the Write-Protect switch to the right to write-protect the cartridge.

Data cannot be written to, or erased from the cartridge.

Move the Write-Protect switch to the left to make the cartridge write-

enabled. Data can now be written to, or erased from the cartridge, assuming it

is not already software write-protected.

Removing the Data Cartridge

To unload a cartridge from the drive, perform the following steps:

❐ Push the Unload button.

The front panel indicators will display the following:

Indicator State, Character, or Message

Status LED

Green, flashing

Single-character display Off

LCD

Cartridge Unloading

In Progress

❐ When the cartridge is ejected from the drive, remove the cartridge.

Caution

After the cartridge is removed from the drive, return it to its plastic case to

prolong the cartridge life.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 64 65

Sem comentários

Quantum 200D/400D Guia do Utilizador Página 32