Quantum SuperLoader 3 Manual do Utilizador descarregar pdf (Página 3)

Dislodging a Stuck Tape 3

Quantum SuperLoader 3

Note: This system error prevents you from entering a Move command through

the OCP.

2 Power cycle the unit using the power switch located at the rear of the system for a

second time. Wait at least 10 seconds after power down before powering on the

unit.

The OCP displays initializes again, as shown in the above figure (see Figure 1).

With the earlier adjustment movement of the tape, the turntable may or may not

rotate freely.

Next, the system attempts to rotate the magazine. This process can take up to 10

minutes.

If the tape is returned to a magazine slot successfully, the OCP displays the following

(see Figure 3).

Figure 3 OCP, System Ready

The OCP can now be used to control movement of the tape and other normal

product operation.

In the event the stuck tape was not removed, proceed to Tape Removal Without

Removing the Top Cover on page 4.

1 2 3 4 5 6 7 8 ... 17 18

Sem comentários

Quantum SuperLoader 3 Manual do Utilizador Página 3