Quantum DAT320 Drive Guia de Início Rápido descarregar pdf (Página 7)

Installing the Internal DAT 320 Tape Drive in Your Server 7

DAT 320

To a n E x te r na l U S B 2. 0 P o r t

Purchase a special USB cable and Cable Routing Kit. The Cable Routing Kit consists of a

bracket with attached cable on one side that connects to the server’s external port and a

Type A USB socket on the other side. Make sure you orientate the bracket correctly when

you fit it (see Figure 4

1 Remove a spare blanking plate from the rear panel of the server.

2 Fit the bracket with attached the cable and fix it to the server. Make sure the cable is

outside of the server and connect it to the server’s external USB port (see Figure 4

3 Attach the standard USB cable to the bracket (type A connector) (see Figure 4

Figure 4 Connecting the USB

Cable

Attaching the Power

and USB Cables to the

Ta p e D r iv e

Note: The drive is not powered from the USB bus. It must be connected to the server's

power supply.

1 Attach the USB cable to the tape drive (Type B connector).

Type B connector

to tape drive

Type A connector on

inside of bracket

Type A connector to

server’s external

USB port

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Sem comentários

Quantum DAT320 Drive Guia de Início Rápido Página 7