Quantum DAT 432/864 Loader Guia do Utilizador descarregar pdf (Página 30)

Operating Your Autoloader Applying Labels

Applying Labels

When applying labels to a cartridge, observe the following precautions to prevent the cartridge

from getting stuck in the autoloader:

• Apply labels firmly, only in recessed label areas on the top side of the cartridge.

• Do not let labels extend beyond label areas or fold over the edge of a cartridge.

• Do not apply labels over other labels.

Loading a Cartridge

Use only approved DAT cartridges in the autoloader. To load cartridges into the magazine, follow

these steps:

1. Make sure that the cartridges are write-protected or write enabled, as necessary. For more

information, refer to “Write-Protecting a DAT Cartridge and Magazine” on page 33.

2. Hold the magazine so that the slot numbers on the side of the magazine are right-side-up.

3. Insert cartridges with the cartridge door facing the magazine slot, as shown in the following

figure.

Figure 9. Loading a Cartridge into the Autoloader Magazine

CAUTION: Do not place any labels on the autoloader magazine, since this may cause the tape

mechanism to jam.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 58 59

Sem comentários

Quantum DAT 432/864 Loader Guia do Utilizador Página 30