Quantum Scalar i40 Guia do Utilizador descarregar pdf (Página 199)

Chapter 6: Performing Library Operations

Cleaning Tape Drives

Quantum Scalar i40 and Scalar i80 User’s Guide 171

Operator Panel

1 Select Actions > Tape Drive > Manual Cleaning.

2 If more than one tape drive is in the library, use the Up and Down

buttons to select a tape drive to clean, then press Clean.

3 When the operation completes, press OK.

Web Client

1 Select Tools > Drive Operations.

2 Select Clean a tape drive and click Next.

3 If more than one partition exists, select the partition that contains

the tape drive you want to clean, and click Next.

The Clean Drive -

Partition (Mode)

screen displays, where

Partition

is the name of the partition and

Mode

is the current mode (online/

offline) of the partition. This screen contains a list of tape drives

assigned to the partition.

4 If you have no cleaning slots configured, skip this step (you will use

the top I/E station slot as the source for your cleaning cartridge). If

you have at least one cleaning slot configured, you are asked to

Select Cleaning Source. Select which location to take the cleaning

cartridge from:

• Use the top I/E slot — Allows you to use a cleaning cartridge

from the topmost I/E station slot. Make sure to install a cleaning

cartridge in the topmost I/E station slot. If manual cartridge

assignment is enabled, assign the cleaning cartridge to the

System partition.

• Use configured cleaning tapes — Allows you to use a cleaning

cartridge from a configured cleaning slot. If two or more

cleaning slots are configured and have cleaning cartridges in

them, the library chooses which cleaning cartridge to use.

5 Select one or more tape drives to clean.

Note: If not all tape drives appear on the screen, use the Page 1

of x arrows to view the additional tape drives.

1 2 ... 194 195 196 197 198 199 200 201 202 203 204 ... 339 340

Sem comentários

Quantum Scalar i40 Guia do Utilizador Página 199