Quantum P1000 Guia do Utilizador descarregar pdf (Página 120)

Appendix B Installing the Slide Assembly in the Rack

Adjusting the Slide Assembly

104 ATL P1000 Series User’s Guide

Procedure (continued)

Move the slide assembly forward or backward as necessary.

When the slide assembly is in the desired position, tighten all outer

nuts:

Pull the slide assembly tray forward until you can access the

four rear screws.

Tighten each of the four rear nuts by holding the nut with an

11/32 inch open-ended wrench and then tightening its

corresponding screw with a Phillips screwdriver.

Extend the slide assembly out of the rack until both the

intermediate and inner channels of the slide rails lock (see

figure 57 on page 105).

The intermediate channels are secured by the intermediate

channel locks, which are located on the inner, back edge of the

intermediate channels.

Release the intermediate channel locks by rotating them

upward slightly.

Note:

Do not release the inner channel locks.

Push the slide assembly back into the rack until the access hole

on the inside of the intermediate channel exposes a screw.

Use a Phillips screwdriver to tighten the screw while holding

its corresponding nut with an 11/32 inch open-ended wrench.

Repeat steps 3e and 3f to tighten the remaining front nuts.

Press on the inner channel locks to release them.

The inner channel locks are located on the outer, back edge of

the inner channels.

Push the slide assembly tray back into the rack.

Check for clearance. If necessary, repeat this procedure to adjust

the slide assembly further.

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 131 132

Sem comentários

Quantum P1000 Guia do Utilizador Página 120