Quantum LTO 1 Informações Técnicas descarregar pdf (Página 9)

Installing the Tabletop LTO-3 Half-Height Tape Drive 9

LTO-3 Half-Height Tape Drive

• See the internal parallel SCSI bus termination examples in figure 3 on page 6

to check/verify the system SCSI bus configuration and install a 68-pin LVD

SCSI bus terminator, as required.

b For the SAS internal drive, attach the internal SAS interface cable to the 7-pin 1x

SATA-style SAS connector on the back of the drive.

3 If you are installing the internal LTO-3 Half-Height Tape Drive in a tape library

system, connect the RS-422 serial interface cable to the serial library port on the back

of the drive. (The serial library port is not used on workstation or server systems.)

4 Connect the internal drive DC power cable to the DC power connector on the back of

the drive.

5 Reinstall the system cover.

6 Reconnect the system AC power cord to the facility AC power receptacle.

After connecting the internal drive interface and DC power cables, proceed to R

estarting

the Internal Tape Drive System in the following subsection.

Restarting the Internal

Tape Drive System 0

After connecting the internal drive interface and DC power cables:

1 Restart the workstation or server system.

2 Verify that the internal LTO-3 Half-Height Tape Drive comes on and completes the

Power On Self Test (POST) functions.

3 As required, proceed to either:

• Installing the LTO Driver Software on page 13

• Registering the LTO-3 Half-Height Tape Drive on page 13

Installing the Tabletop LTO-3 Half-Height Tape Drive

To install the tabletop LTO-3 Half-Height Tape Drive, complete the following procedures

in the order presented:

1 Depending on the interface configuration of the drive:

IF the drive interface is . . . THEN . . .

parallel Small Computer

System Interface (SCSI),

proceed to Configuring the Tabletop Parallel SCSI

Tape Drive in the following subsection to configure

the SCSI ID.

serial-attached SCSI (SAS), there is no need to configure the SCSI ID, as SAS

is a point-to-point architecture. Skip to C

onnecting

the Tabletop Drive Interface and AC Power Cables

on page 11.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sem comentários

Quantum LTO 1 Informações Técnicas Página 9