Quantum DLT 8000 Guia do Utilizador descarregar pdf (Página 14)

6 Sun StorEdge DLT8000 Tape Drive Installation and User’s Guide • February 2001

Troubleshooting

If the tape drive fails during POST or operation, use Table 1-1 to identify the

problem and determine what action to take.

TABLE 1-1 Troubleshooting

Symptom: Your system does not recognize the DLT8000 tape drive.

Action:

Make sure that:

• The SCSI ID is unique.

• The SCSI cable is not loose.

• The SCSI bus is correctly terminated.

• You have rebooted the system using the boot -r command.

Symptom: All LEDs on the right or left side of the tape drive front panel blink.

Action:

Unload the tape and reinitialize the drive by pressing the Unload

button, or power off the tape drive, wait 15 seconds, and then

power it on again. The right or left side LEDs should stop blinking,

and the drive should try to reinitialize. If the test succeeds, the

LEDs should turn on steady, and then turn off.

If all right or left side LEDs continue blinking, the drive has a

hardware failure.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 33 34

Sem comentários

Quantum DLT 8000 Guia do Utilizador Página 14