Quantum P3000 Guia do Utilizador descarregar pdf (Página 44)

Chapter 2 Basic Library Operations

Using the GUI

24 Quantum|ATL P3000 Series User’s Guide

Verify that the CHM is empty by checking the Overview screen

on the GUI (see chapter 3,

Operator Commands).

If there is a tape cartridge in the CHM, perform a Move

command to place the cartridge in an available bin.

Turn off the power switch located below the GUI.

Using the GUI

The GUI is activated by touching the screen, and is located on the

front of the library. The menus displayed on the GUI allow you to

obtain information about the library, execute library commands,

and test library functions (see figure 12

The GUI’s functions are grouped into the following four screens:

• Overview screen—displays current tape drive, CHM, and load

port content and activities.

• Tapes screen—displays tape drive, storage bin, load port, and

gripper inventories.

• Operator screen—contains library configuration and control

functions (password protected).

• Service screen—contains reporting functions, system tests, and

service commands (password protected).

• Multi-Unit screen—contains multi-unit configuration and

calibration.

Note:

Wait ten seconds before turning on the power switch

again.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 145 146

Sem comentários

Quantum P3000 Guia do Utilizador Página 44