Quantum DX30 Guia do Utilizador descarregar pdf (Página 42)

Chapter 3 OpenView NNM on Solaris

Duplicate IP Addresses

28 SNMP Integration Guide

Duplicate IP Addresses 3

As a final step in the SNMP integration with HP OpenView NNM, an

entry needs to be added the HP OpenView nodiscover file. This entry is

necessary to ensure that the IP address of the second Ethernet port on the

PMC is not detected as a duplicate IP address when more than one PMC

is attached to a network. Before powering on the library containing the

PMC, perform the duplicate IP addresses procedure.

To create duplicate IP addresses:

1 Determine the IP address of the PMC Ethernet port.

If the IP address of the PMC Ethernet port attached to the network

begins with anything other than the number 10, the IP address of the

second port is

10.0.0.254. Otherwise, the IP address of the second

Ethernet port is

192.168.0.254.

2 Create an ASCII file. Name and place it as follows:

$OV_CONF/netmon.noDiscover

3 Add a line to the file containing only the IP address determined in

step 1

of this section.

For example, if the IP address of the second Ethernet port is

determined to be

10.0.0.254, then add the following line to the file:

10.0.0.254 #MC300 private network address.

Setting Up OpenView NNM 3

After the SNMP integration software is installed, set up OpenView NNM.

To set up OpenView NNM:

1 If OpenView NNM is running, shutdown and restart OpenView

NNM.

If OpenView NNM is not running, start OpenView NNM. To run

OpenView NNM, type:

#opt/OV/bin/ovstart

#opt/OV/bin/ovw

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 57 58

Sem comentários

Quantum DX30 Guia do Utilizador Página 42