Quantum Tape Drive A-Series Manual do Utilizador descarregar pdf (Página 83)

Cleaning the Tape Mechanism

Quantum A-Series Tape Drives User’s Guide 67

2 Observe that both the Status and Activity LEDs are on steady during

the cleaning process.

3 After the cleaning process completes, depending on the drive

configuration, either:

a The drive automatically ejects the LTO cleaning cartridge, or

b You must press the tape load/unload button to eject the LTO

cleaning cartridge.

4 Write the date on the cartridge label for future reference.

Each time you use the LTO cleaning cartridge, the cleaning media

advances to a new, unused section. After approximately 50 cleanings, all

of the media will be used up and the A-Series LTO-3 tape drive:

• Turns on the green

Activity LED

• Fast flashes the amber

Status LED

• Ejects the LTO cleaning cartridge

Always discard used-up LTO cleaning cartridges.

Note: If the A-Series LTO-3A tape drive does not recognize the

cartridge as an LTO cleaning cartridge, the drive stops the

cleaning process and ejects the cartridge.

Note: If the amber

Status LED comes on continuously within 24

hours after a cleaning cycle, perform the cleaning procedure

again. If, after three cleaning cycles in a 72-hour period, the

amber

Status LED comes on again, contact Quantum

Technical Support.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 104 105

Sem comentários

Quantum Tape Drive A-Series Manual do Utilizador Página 83