Quantum Scalar i500 Manual do Utilizador descarregar pdf (Página 13)

Scalar i500 Getting Started Guide 13

Step 4: Install the Module Components

For instructions on any of the following steps, see “Adding, Removing, and Replacing” in the Scalar i500

User’s Guide.

1 If not already installed, install the library control blade (LCB) in the control module.

2 Install the tape drives.

3 Install the power supplies.

4 Install the Fibre Channel (FC) I/O blade (if required and not already installed).

5 Close the library’s I/E station door and access door.

Step 5: Connect the Tape Drive Cables

Follow the instructions below for the type(s) of tape drives installed in your library. The instruction sets are:

• Connecting Parallel SCSI Cables

• Connecting Fibre Channel Cables Directly to Host or Switch

• Connecting Fibre Channel Cables Through an I/O Blade

• Connecting Serial Attached SCSI (SAS) Cables

A library can have any combination of SCSI, FC, and SAS drives, connected directly to hosts or through I/

O blades. You may need to follow more than one set of instructions below. For more detailed instructions,

see the Scalar i500 User’s Guide.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 147 148

Sem comentários

Quantum Scalar i500 Manual do Utilizador Página 13