Quantum DAT 160 Guia do Utilizador descarregar pdf (Página 19)

Chapter 1 Introduction

LED Action Sequences

Quantum DAT 160 User’s Guide 5

Ready is ON.

The drive is ready for

operation.

None. This is normal.

Ready FLASHES.

The drive is carrying out a

normal activity (read, write).

None.

If the drive is upgrading firmware, do not reset or

power cycle it.

Clean FLASHES.

The drive requires cleaning. Load the cleaning cartridge.

If the Clean LED is still flashing when you load a

new or known good data cartridge after cleaning,

call for service.

Ready FLASHES and

Clean is ON.

Cleaning is in progress. None. The cleaning cartridge will eject on completion.

The cleaning cycle can take up to 5 minutes to

complete.

Tape FLASHES.

The drive believes the current

tape or the tape just ejected is

faulty.

Unload the tape cartridge. Make sure that you are using

the correct format cartridge.

Reload the cartridge. If the Tape LED still flashes or

starts flashing during the next backup, load a new or

known good cartridge.

If the Tape LED is now off, discard the 'suspect' tape

cartridge. If it is still on, call for service.

Drive FLASHES.

The drive mechanism has

detected an error.

Load a new cartridge. If the error persists, power cycle

or reset the drive.

If the Drive LED remains on, call for service.

Drive, Tape and Ready

FLASH.

There is a firmware download

problem.

Insert a cartridge to clear the LED sequence. If the

condition persists, call for service.

LED Sequence Cause Action required

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 81 82

Comentários a estes Manuais

Sem comentários

Quantum DAT 160 Guia do Utilizador Página 19

Comentários a estes Manuais

Manuais e produtos relacionados com Suportes magnéticos para dados Quantum DAT 160